The influence of processing additives on the processability and properties of styrene-butadiene rubber
Abstract
Short review devoted to prediction of phase morphologies of heterogeneous polymer blends with the aim of the development of novel composite polymeric materials. The works discussed are performed mainly at the department of chemistry and physics of polymers and polymeric materials.
About the Authors
D. V. Sitnikova
M.V. Lomonosov Moscow State University of Fine Chemical Technologies, 86, Vernadskogo pr., Moscow 119571
Russian Federation
Russian Federation
A. M. Bukanov
M.V. Lomonosov Moscow State University of Fine Chemical Technologies, 86, Vernadskogo pr., Moscow 119571
Russian Federation
Russian Federation
References
1. Гришин Б.С. Материалы резиновой промышленности (инф.-аналит. база данных): в 2 ч. - Казань: КГТУ, 2010. Ч. 1. 506 с.
2. Карманова О.В. Технологические активные добавки на основе сопутствующих продуктов производства растительного масла // Каучук и резина. 2009. № 5. С. 18-21.
3. Осошник И.А. Производство резиновых технических изделий. - Воронеж: ВГТА, 2007. 972 с.
For citation:
Sitnikova D.V., Bukanov A.M. The influence of processing additives on the processability and properties of styrene-butadiene rubber. Fine Chemical Technologies. 2011;6(5):143-145. (In Russ.)
Views: 149
Email this article 