chemicallytechFine Chemical TechnologiesТонкие химические технологии2410-65932686-7575MIREA – Russian Technological University (RTU MIREA).10.32362/2410-6593-2016-11-53-58chemicallytech-8Research ArticleSYNTHESIS AND PROCESSING OF POLYMERS AND POLYMERIC COMPOSITESСИНТЕЗ И ПЕРЕРАБОТКА ПОЛИМЕРОВ И КОМПОЗИТОВ НА ИХ ОСНОВЕTHE INFLUNCE OF TEMPERATURE MODE ON KINETICS OF SODIUM METHACRYLATE AND METHACRYLIC ACID AMIDE COPOLYMERIZATIONВЛИЯНИЕ ТЕМПЕРАТУРНОГО РЕЖИМА НА КИНЕТИКУ СОПОЛИМЕРИЗАЦИИ МЕТАКРИЛАТА НАТРИЯ С АМИДОМ МЕТАКРИЛОВОЙ КИСЛОТЫЛипинА. А.LipinА. А.

доцент

Ivanovo, 153000 Russia

lipin.a@mail.ruЛипинА. Г.LipinА. G.

профессор

Ivanovo, 153000 Russia

noemail@neicon.ruШибашовА. В.ShibashovА. V.

доцент

Ivanovo, 153000 Russia

noemail@neicon.ruИвановский государственный химико-технологический университетРоссияIvanovo State University of Chemistry and TechnologyRussian Federation2016280220161115358Copyright © Lipin А.А., Lipin А.G., Shibashov А.V., 20162016Липин А.А., Липин А.Г., Шибашов А.В.Lipin А.А., Lipin А.G., Shibashov А.V.Данная работа распространяется под лицензией Creative Commons Attribution 4.0.This work is licensed under a Creative Commons Attribution 4.0 License.https://www.finechem-mirea.ru/jour/article/view/8

Experimental studies of sodium methacrylate and methacrylamide copolymerization in aqueous solutions with a total monomer content of 34-50% were accomplished. Potassium persulfate was used as the initiator. Three variants of the process operation conditions were investigated: isothermal, quasi-isothermal and adiabatic. The effect of temperature, initial concentration of monomers and initiator on the rate of copolymerization, the extent of monomers conversion, the duration of the process, the reaction mass viscosity were studied under isothermal conditions. The copolymerization takes place at a constant rate at all temperatures in the range of 55-80°C until conversion is less than 70%. This behavior is typical for the polymerization system with initial total concentration of monomers of about 4.4 mol·L-1 and above. It is found that the reaction rate is directly proportional to the initial concentration of the reaction system. Increasing temperature reduces the viscosity of a 1% aqueous solution of the product, thus reducing the average molecular weight of the copolymer. By means of studying the copolymerization under adiabatic conditions the dependences of the monomers conversion degree, the viscosity of a 1% aqueous solution of the product and the reaction mass temperature upon copolymerization time were obtained. In the adiabatic mode the monomers conversion is less than 70%, the viscosity of a 1% solution of the reaction mass is approximately 13·10-6 m2/s, and the temperature rises to ~ 120°C. The product is a polymer gel, water-swellable and soluble in an aqueous alkaline medium. The quasi-isothermal mode of copolymerization with the same duration allows obtaining the degree of conversion of about 94% and a viscosity of the reaction mass of about 400·10-6 m2/s. An important advantage of the copolymer obtained in the quasi-isothermal mode as compared to that obtained in the adiabatic conditions is complete water solubility. Based on experimental results, the recommended conditions for the sodium methacrylate and methacrylamide copolymerization are as follows: the monomers concentration in the reaction mass is 5.55-6.75 mol·L-1; initiator concentration is 2·10-3 - 6·10-3 mol·L-1; copolymerization temperature is 55-65°C.

Выполнены экспериментальные исследования сополимеризации метакрилата натрия с амидом метакриловой кислоты в концентрированных водных растворах в изотермическом, квазиизотермическом и в адиабатическом режимах. Показано, что только в квазиизотермическом режиме проведения сополимеризации происходит образование водорастворимого сополимера с высокой степенью превращения и вязкостью, отвечающей требуемым качественным показателям продукта. На основе анализа результатов экспериментальных исследований рекомендованы режимные параметры осуществления процесса.

водорастворимые полимерыакриловые полимерыметакрилат натрияметакриламидсополимеризацияwater-soluble polymersacrylic polymerssodium methacrylatemethacrylamidecopolymerizationReferencesBolívar G., Mas M., Ramírez M., Tortolero M., Cañizales E. // Revista Latinoamericana de Metalurgia y Materiales. 2011-12. V. 31. № 2. P. 150-160.Bolívar G., Mas M., Ramírez M., Tortolero M.,; Cañizales E. // Revista Latinoamericana de Metalurgia y Materiales. 2011-12. V. 31. № 2. P. 150–160.Sadeghalvaad M., Sabbaghi S. // Powder Technology. 2015. V. 272. P. 113-119.Sadeghalvaad M., Sabbaghi S. // Powder Technology. 2015. V. 272. P. 113–119.Ashraf S., Cluley A., Mercado C., Mueller A. // Water Science and Technology. 2011. V. 64. № 6. P. 1325-1332.Ashraf S., Cluley A., Mercado C., Mueller A. // Water Science and Technology. 2011. V. 64. № 6. P. 1325–1332.Басова Т.Г., Зильберман Е.Н., Шварева Г.Н., Черных В.Н. // Высокомолек. соединения. 1975. Т. 17 Б. № 5. С. 379-380.Basova T.G., Zilberman E.N., Shvareva G.N., Chernych V.N. // Polymer science. 1975. V. 17 B. № 5. P. 379–380.Басова Т.Г. // Изв. ВУЗов. Химия и хим. технология. 1975. № 8. С. 1827-1829.Basova T.G. // Izvestiya Vysshikh Uchebnykh Zavedenii, Khimiya i Khimicheskaya Tekhnologiya [Proceedings of the higher educational institutions. Chemistry and chemical technology]. 1975. № 8. P. 1827–1829.Шубин А.А., Кисельников В.Н., Вялков В.В., Шварева Г.Н. // Изв. вузов. Химия и хим. технология. 1983. Т. 26. Вып. 10. С. 1249-1253.Shubin А.А., Kiselnikov V.N., Vyalkov V.V., Shvareva G.N. // Izvestiya Vysshikh Uchebnykh Zavedenii, Khimiya i Khimicheskaya Tekhnologiya [Proceedings of the higher educational institutions. Chemistry and chemical technology]. 1983. V. 26. № 10. P. 1249–1253.Липин А.Г., Бубнов В.Б., Шубин А.А., Лебедев В.Я. // Изв. ВУЗов. Химия и хим.технология. 1999. Т. 42. № 4. С. 71-73.Lipin A.G., Bubnov V.B., Shubin A.A., Lebedev V. Ya. // Izvestiya Vysshikh Uchebnykh Zavedenii, Khimiya i Khimicheskaya Tekhnologiya [Proceedings of the higher educational institutions. Chemistry and chemical technology]. 1999. V. 42. № 4. P. 71–73.Kuo Jen-Feng, Chen Chuh-Yung, Luo Shieh-Huang, Pan Ting-Chung // J. Applied Polymer Science. 1989. V. 38. № 3. P. 529-537.Kuo Jen-Feng, Chen Chuh-Yung, Luo ShiehHuang, Pan Ting-Chung // J. Applied Polymer Science. 1989. V. 38. № 3. P. 529–537.Lipin A.A., Shibashov A.V., Lipin A.G. // Russian J. Applied Chemistry. 2015. V. 88. № 1. P. 97-102.Lipin A.A., Shibashov A.V., Lipin A.G. // Russian J. Applied Chemistry. 2015. V. 88. № 1. P. 97−102.Липин А.А., Шибанов А.В., Липин А.Г. // Изв. Вузов. Химия и хим. технология. 2014. Т. 57. № 12. С. 85-87.Lipin A.A., Shibashov A.V., Lipin A.G. // Izvestiya Vysshikh Uchebnykh Zavedenii, Khimiya i Khimicheskaya Tekhnologiya [Proceedings of the higher educational institutions. Chemistry and chemical technology]. 2014. V. 57. № 12. P. 85–87.Аверко-Антонович И.Ю., Бикмуллин Р.Т. Методы исследования структуры и свойств полимеров: уч. пособие. Казань: КГТУ, 2002. 604 с.Averko-Antonovich I.Yu., Bikmullin R.T. Metody issledovaniya struktury i svoistv polimerov [Methods of polymers structure and properties investigation]. Kazan’: КSTU, 2002. 604 p.Абрамова Л.И., Байбурдов Т.А., Григорян Э.П., Зильберман Е.Н., Куренков В.Ф., Мягченков В.А. Полиакриламид / Под ред. В.Ф. Куренкова. М.: Химия, 1992. 192 с.Abramova L.I., Baiburdov T.A., Grigoryan E.P., Zilberman E.N., Kurenkov V.F., Myagchenkov V.A. Poliakrilamid [Polyacrylamide]. Moscow: Khimiya, 1992. 192 p.

The authors declare that there are no conflicts of interest present.