<?xml version="1.0" encoding="UTF-8"?>
<!DOCTYPE article PUBLIC "-//NLM//DTD JATS (Z39.96) Journal Publishing DTD v1.3 20210610//EN" "JATS-journalpublishing1-3.dtd">
<article article-type="research-article" dtd-version="1.3" xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink" xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance" xml:lang="en"><front><journal-meta><journal-id journal-id-type="publisher-id">chemicallytech</journal-id><journal-title-group><journal-title xml:lang="en">Fine Chemical Technologies</journal-title><trans-title-group xml:lang="ru"><trans-title>Тонкие химические технологии</trans-title></trans-title-group></journal-title-group><issn pub-type="ppub">2410-6593</issn><issn pub-type="epub">2686-7575</issn><publisher><publisher-name>MIREA – Russian Technological University (RTU MIREA).</publisher-name></publisher></journal-meta><article-meta><article-id pub-id-type="doi">10.32362/2410-6593-2016-11-6-103-107</article-id><article-id custom-type="elpub" pub-id-type="custom">chemicallytech-66</article-id><article-categories><subj-group subj-group-type="heading"><subject>Research Article</subject></subj-group><subj-group subj-group-type="section-heading" xml:lang="en"><subject>SYNTHESIS AND PROCESSING OF POLYMERS AND POLYMERIC COMPOSITES</subject></subj-group><subj-group subj-group-type="section-heading" xml:lang="ru"><subject>СИНТЕЗ И ПЕРЕРАБОТКА ПОЛИМЕРОВ И КОМПОЗИТОВ НА ИХ ОСНОВЕ</subject></subj-group></article-categories><title-group><article-title>THE INFLUENCE OF DILUENTS ON THE KINETICS OF VOLUME SHRINKAGE AND STRESS UPON CURING OF EPOXY OLIGOMERS</article-title><trans-title-group xml:lang="ru"><trans-title>ВЛИЯНИЕ РАЗБАВИТЕЛЕЙ НА КИНЕТИКУ ОБЪЕМНОЙ УСАДКИ И НАПРЯЖЕНИЙ ПРИ ОТВЕРЖДЕНИИ ЭПОКСИДИАНОВЫХ ОЛИГОМЕРОВ</trans-title></trans-title-group></title-group><contrib-group><contrib contrib-type="author" corresp="yes"><name-alternatives><name name-style="eastern" xml:lang="ru"><surname>Трофимов</surname><given-names>А. Н.</given-names></name><name name-style="western" xml:lang="en"><surname>Trofimov</surname><given-names>A. N.</given-names></name></name-alternatives><bio xml:lang="ru"><p>исполнительный директор</p><p>Московская область, 141551 Россия</p></bio><bio xml:lang="en"><p>Moscow region, 141551 Russia</p></bio><email xlink:type="simple">noemail@neicon.ru</email><xref ref-type="aff" rid="aff-1"/></contrib><contrib contrib-type="author" corresp="yes"><name-alternatives><name name-style="eastern" xml:lang="ru"><surname>Апексимов</surname><given-names>Н. В.</given-names></name><name name-style="western" xml:lang="en"><surname>Apeksimov</surname><given-names>N. V.</given-names></name></name-alternatives><bio xml:lang="ru"><p>ассистент, Кафедра химии и технологии переработки пластмасс и полимерных композитов</p><p> </p></bio><bio xml:lang="en"><p>Moscow, 119571 Russia</p></bio><email xlink:type="simple">apeksimov@mirea.ru</email><xref ref-type="aff" rid="aff-2"/></contrib><contrib contrib-type="author" corresp="yes"><name-alternatives><name name-style="eastern" xml:lang="ru"><surname>Симонов-Емельянов</surname><given-names>И. Д.</given-names></name><name name-style="western" xml:lang="en"><surname>Simonov-Emelyanov</surname><given-names>I. D.</given-names></name></name-alternatives><bio xml:lang="ru"><p>заведующий кафедрой, Кафедра химии и технологии переработки пластмасс и полимерных композитов</p><p> </p></bio><bio xml:lang="en"><p>Moscow, 119571 Russia</p></bio><email xlink:type="simple">noemail@neicon.ru</email><xref ref-type="aff" rid="aff-2"/></contrib><contrib contrib-type="author" corresp="yes"><name-alternatives><name name-style="eastern" xml:lang="ru"><surname>Прохорова</surname><given-names>Ю. С.</given-names></name><name name-style="western" xml:lang="en"><surname>Prokhorova</surname><given-names>Yu. S.</given-names></name></name-alternatives><bio xml:lang="ru"><p>инженер</p><p> </p></bio><bio xml:lang="en"><p>Moscow region, 141551 Russia</p></bio><email xlink:type="simple">noemail@neicon.ru</email><xref ref-type="aff" rid="aff-1"/></contrib></contrib-group><aff-alternatives id="aff-1"><aff xml:lang="ru"><institution>ОАО «НПО Стеклопластик»</institution><country>Россия</country></aff><aff xml:lang="en"><institution>JSC "NPO Stekloplastik"</institution><country>Russian Federation</country></aff></aff-alternatives><aff-alternatives id="aff-2"><aff xml:lang="ru"><institution>Московский технологический университет (Институт тонких химических технологий)</institution><country>Россия</country></aff><aff xml:lang="en"><institution>Moscow Technological University (Institute of Fine Chemical Technologies)</institution><country>Russian Federation</country></aff></aff-alternatives><pub-date pub-type="collection"><year>2016</year></pub-date><pub-date pub-type="epub"><day>28</day><month>12</month><year>2016</year></pub-date><volume>11</volume><issue>6</issue><fpage>103</fpage><lpage>107</lpage><permissions><copyright-statement>Copyright &amp;#x00A9; Trofimov A.N., Apeksimov N.V., Simonov-Emelyanov I.D., Prokhorova Y.S., 2016</copyright-statement><copyright-year>2016</copyright-year><copyright-holder xml:lang="ru">Трофимов А.Н., Апексимов Н.В., Симонов-Емельянов И.Д., Прохорова Ю.С.</copyright-holder><copyright-holder xml:lang="en">Trofimov A.N., Apeksimov N.V., Simonov-Emelyanov I.D., Prokhorova Y.S.</copyright-holder><license xml:lang="ru" license-type="creative-commons-attribution" xlink:href="https://creativecommons.org/licenses/by/4.0/" xlink:type="simple"><license-p>Данная работа распространяется под лицензией Creative Commons Attribution 4.0.</license-p></license><license xml:lang="en" license-type="creative-commons-attribution" xlink:href="https://creativecommons.org/licenses/by/4.0/" xlink:type="simple"><license-p>This work is licensed under a Creative Commons Attribution 4.0 License.</license-p></license></permissions><self-uri xlink:href="https://www.finechem-mirea.ru/jour/article/view/66">https://www.finechem-mirea.ru/jour/article/view/66</self-uri><abstract><p>It is known that for decrease in viscosity polymeric binding on the basis of epoxy oligomers in their composition injecting solvents of the different nature and thermodynamic compatibility. In this paper the dependences describing influence on shrinkage, kinetics of increase and maximum level of strains from diluents content and temperature of curing of epoxy oligomers are established. Introduction about 20 % of the active diluents (DEG-1 and SO-3) in system on the basis of epoxy oligomers leads to decrease in viscosity in ~3 times, to improvement of imbibition quality of fibrous fillers, increase of volume contraction (on ~2.5. %) and decrease in residual stresses in ~6 times as a result of increase of mobility of pieces of a polymeric chain in a three-dimensional grid, and also to decrease in glass transition temperature no more than ~20°C.</p></abstract><trans-abstract xml:lang="ru"><p>Рассматривается влияние активных и инактивных разбавителей на кинетику объемной усадки и напряжений при отверждении эпоксидиановых олигомеров. Установлены зависимости, описывающие влияние на усадку, кинетику нарастания и максимальный уровень напряжений содержания разбавителей и температуры отверждения эпоксидных олигомеров. Введение до ~20% активных разбавителей (ДЭГ-1 и СО-3) в систему на основе эпоксидных олигомеров приводит к снижению вязкости в ~3 раза, улучшению качества пропитки волокнистых наполнителей, увеличению усадки (на ~2,5.%) и уменьшению остаточных напряжений в ~6 раз в результате увеличения подвижности сегментов полимерной цепи в трехмерной сетке, а также к снижению температуры стеклования не более чем ~20°С.</p></trans-abstract><kwd-group xml:lang="ru"><kwd>матрица</kwd><kwd>разбавитель</kwd><kwd>эпоксидная смола</kwd><kwd>обобщенные параметры структуры</kwd></kwd-group><kwd-group xml:lang="en"><kwd>epoxy resin</kwd><kwd>diluents</kwd><kwd>generalized structure parameters</kwd></kwd-group></article-meta></front><back><ref-list><title>References</title><ref id="cit1"><label>1</label><citation-alternatives><mixed-citation xml:lang="ru">Справочник по композиционным материалам: В 2-х кн. / Под ред. Дж. Любина; пер. с англ. А.Б. Геллера, М.М. Гельмонта; под ред. Б.Э. Геллера. М.: Машиностроение, 1988. 448 с.</mixed-citation><mixed-citation xml:lang="en">Handbook of composite materials: In 2 vol. / Ed. J. Lubin; Trans. from English. A.B. Geller, M. Gelmont; Ed. B.E. Geller. M.: Mashinostroenie Publ., 1988. 448 p. (in Russ.).</mixed-citation></citation-alternatives></ref><ref id="cit2"><label>2</label><citation-alternatives><mixed-citation xml:lang="ru">Симонов-Емельянов И.Д., Трофимов А.Н., Апексимов Н.В., Шулаев Н.С. // Клеи. Герметики. Технологии. 2015. № 2. С. 23-27.</mixed-citation><mixed-citation xml:lang="en">Simonov-Emelyanov I.D., Trofimov A.N., Apeksimov N.V., Shulaev N.S. Klei. Germetiki. Tekhnologii (Adhesives. Sealants. Technologies). 2015. № 2. P. 23–27. (in Russ.).</mixed-citation></citation-alternatives></ref><ref id="cit3"><label>3</label><citation-alternatives><mixed-citation xml:lang="ru">Симонов-Емельянов И.Д., Апексимов Н.В., Трофимов А.Н., Суриков П.В., Хомяков А.К. // Вестник МИТХТ. 2011. Т. 6. № 4. С. 89-92.</mixed-citation><mixed-citation xml:lang="en">Simonov-Emelyanov I.D., Apeksimov N.V., Trofimov A.N., Surikov P.V., Homyakov A.K. Vestnik MITHT (Fine Chemical Technologies). 2011. T. 6. № 4. P. 89–92. (in Russ.).</mixed-citation></citation-alternatives></ref><ref id="cit4"><label>4</label><citation-alternatives><mixed-citation xml:lang="ru">Кандырин Л.Б., Саматадзе А.И, Суриков П.В., Кулезнев В.Н. // Пластические массы. 2010. № 9. С. 35-39.</mixed-citation><mixed-citation xml:lang="en">Mezhikovskii S.M., Irzhak V.I. Chemical Physics of Oligomers Curing. Moscow: Nauka Publ., 2008. 269 p. (in Russ.).</mixed-citation></citation-alternatives></ref><ref id="cit5"><label>5</label><citation-alternatives><mixed-citation xml:lang="ru">Межиковский С.М., Иржак В.И. Химическая физика отверждения олигомеров. М.: Наука, 2008. 269 с.</mixed-citation><mixed-citation xml:lang="en">Kandyrin L.B., Samatadze A.I., Surikov P.V., Kuleznev V.N. Plasticheskiye massi (Plastics). 2010. № 9. P. 35–39. (in Russ.).</mixed-citation></citation-alternatives></ref><ref id="cit6"><label>6</label><citation-alternatives><mixed-citation xml:lang="ru">Хозин В.Г. Усиление эпоксидных полимеров. Казань: ПИК«Дом печати», 2004. 446 с.</mixed-citation><mixed-citation xml:lang="en">Khozin V.G. Strengthening of Epoxy Polymers. Kazan: PIK "Printing House", 2004. 446 p. (in Russ.).</mixed-citation></citation-alternatives></ref></ref-list><fn-group><fn fn-type="conflict"><p>The authors declare that there are no conflicts of interest present.</p></fn></fn-group></back></article>
